#DSP QUATTRO NO SUCH VOLUME INSTALL#

Volume gets louder every time a new application is started etc/pulse/nf or ~/.config/pulse/nf flat-volumes = noĪnd then restarting PulseAudio by executing If this is found to be inconvenient, asinine, or otherwise undesireable, relative volumes can be enabled by disabling flat volumes in the PulseAudio daemon's configuration file: This is because PulseAudio uses flat volumes by default, instead of relative volumes, relative to an absolute master volume. Per-application volumes change when the Master volume is adjusted Try using larger values when changing volume (e.g. If the volume does not appear to increment/decrement properly using alsamixer or amixer, it may be due to PulseAudio having a larger number of increments (65537 to be exact). Volume adjustment does not work properlyĬheck /usr/share/alsa-card-profile/mixer/paths/. If it is still absent, verify that other applications show up as sink inputs. Note: If pacmd reports 0 sink input(s), double-check that the application is playing audio. If the volume needs adjusting, it can be set to 100% by:

If the sink is muted, it can be unmuted by: Ensure sane settings are present, specifically those of muted and volume. The properties: application.name and, among others, should help here. With the offending application playing audio, run:įind and make note of the index of the corresponding sink input. If a specific application is muted or low while all else seems to be in order, it may be due to individual sink-input settings. This will cause amixer to ask PulseAudio to do the toggling rather than toggling it directly.īecause of this, PulseAudio will correctly unmute Master as well as any applicable output. To resolve this, amixer must have the device flag set to 'pulse': 'Headphone' and 'Speaker'), using plain amixer to toggle Master can trigger PulseAudio to mute the active output too, but it does not necessarily unmute it when Master is toggled back to be unmuted. Output stuck muted while Master is toggled If it displays a low percentage value, you can run pamixer -i 10 several times to turn up the volume gradually. If the output says muted, run pamixer -u to unmute.

#DSP QUATTRO NO SUCH VOLUME INSTALL#

To troubleshoot via CLI only, install pamixer and check the output of the following command: Install pavucontrol and check if there is any output on the pavucontrol panel when playing a. One possible cause of no sound after install is that PulseAudio detects the wrong output device as a default. Note: alsamixer will not tell you which output device is set as the default.

Dsp quattro no such volume